The diagram of how to adjust the mixer reverb is as follows:

First, open the mixer and click "View" - "Mixer" in the top menu bar of FL Studio arrangement software. The second is to click on slot 1 on the right side of "Mixer" and then select "Fruity Reeverb 2" to open the reverb effector.

Computer model: Huawei MagicBook.

System: window10 system.

FL Studio version: 20.8.

First, open the mixer and click "View" - "Mixer" on the top menu bar of FL Studio arrangement software.

The second is to click on slot 1 on the right side of "Mixer" and then select "Fruity Reeverb 2" to open the reverb effector. You can see the parameters of the reverb effector from left to right. The far left is high cut and low cut. The middle is delay, size, modulation, scattering, speed, bass, attenuation, crossover and damping. The far right is dry sound. , ER, wet tone, separation.

How the mixer can achieve the best results:

1. Sound quality compensation: Sound quality compensation is to use a sound quality compensator to adjust the center frequency of each frequency band to change the timbre of the sound.

2. Volume adjustment: Before tuning, you must have a clear understanding of the dynamic level and frequency characteristics of the original sound signal as well as the proportional relationship between the various signals on site. This requires multiple auditions and repetitions. When debugging, the various conditions and playback effects of future playback should also be taken into consideration.

3. Signal input: From top to bottom are the tweeter XLR sockets and receiver inputs, which usually provide conversion power.

4. Plug into socket: The insertion point is usually located in the input channel of the tuning table, that is, in front of the signal path, sometimes directly in the channel input. Typically this dynamic processor insertion point is used.

5. Sound control panel: There is a four-segment control panel, where we can adjust high, medium and low signal frequencies for each path.