10 1: Interrupt failed.
102: Clock failure
103: Time interrupt failed.
104: Protection mode failed.
105: The last 8042 command was not accepted.
107: NMI detection failed.
108: Clock bus detection failed.
109: motherboard of low Meg chip selection detection system. nm 1 10。
If an expansion unit is connected to the computer, please remove the system motherboard 1 1 1.
I/O parity check memory expansion unit or port replicator system motherboard. 1 1xx
1101:Class A equipment detection failed. Serial device communication wiring system motherboard 12XX.
1201:motherboard of class b fault detection system (infrared) 158.
Even if the administrator password is set, the hard disk password will not be set. Set the hard disk password 159.
The hard disk password is different from the administrator password. Setting the hard disk password is the same as the administrator password 16 1.
Battery fault detection spare battery spare battery system motherboard. 163
Time and date are not set. Set the time and date system motherboard. 173。
Device data loss Select OK on the screen, and then set the time and date to back up the battery system motherboard. 174。
Setup error: First test the list of installed devices, and then change the configuration of FRU component test devices. 0 175.
Error in CRC 1, stop publishing task. Error in EEPROM verification. System motherboard 0 177.
Supervisor password verification error system motherboard 0 178
EEPROM fault system motherboard 17XX
170 1: Hard disk controller failure.
1780, 1790: Error in hard disk 0.
178 1, 179 1: hard disk 1 wrong hard disk drive system motherboard 183.
Incorrect input when prompted for supervisor password. Enter the correct administrator password 184.
Power-on password verification error. Enter the BIOS settings and reset the power-on password 185.
Illegal boot sequence: enter the BIOS settings and reset the boot sequence 186 1 system motherboard 0 187.
EAIA data reading error. Unable to read EEPROM. System motherboard 0 188
Illegal RFID continuous information area or CRC2 error. Error in EEPROM verification. System motherboard 0 189
Illegal RFID continuous information area. Error in EEPROM verification. System motherboard 0 190
The battery is extremely low. An error occurred while charging the battery. Battery compartment 0 193.
The RF antenna has been removed. Enter the administrator password 0 194.
Carry a notebook and enter the supervisor password 0 195 through the security door.
Security hardware is disturbed. Enter the administrator password and enter the BIOS setup tool. Select Configure, IBM Security Chip, and Clear IBM Security Chip to clear this error. Security chip system motherboard 0 196.
The security hardware was removed. Enter the administrator password and enter the BIOS setup tool. Select Configure, IBM Security Chip, and Clear IBM Security Chip to clear this error. Security chip system motherboard 0 197.
Illegal remote modification requires that the remote configuration of the security chip fails. Please confirm the operation and try 0 1C8 again.
Multiple modem devices-delete one and press Esc to continue. Remove the MiniPCI modem card or modem daughter card, or press Esc to ignore the error and continue. System motherboard 0 1C9
Multiple network devices-delete one and press Esc to continue. Remove the MiniPCI Ethernet card or Ethernet daughter card, or press Esc to ignore the error and continue. System motherboard 0200
The hard disk is wrong. The hard disk is broken Reinstall the hard disk (remove) and restore the default settings in the BIOS setup tool. Hard disk drive system motherboard 021x.
Keyboard misoperation test of interactive keyboard and auxiliary input device 0220
Wrong monitor type. Monitor type does not match CMOS definition. Restore the default setting 0230 in the BIOS setup tool.
Mapping memory error. Error in offset nnnn in mapping. System motherboard 023 1.
System memory error. There is an error in the offset nnnn in the system memory. Memory system motherboard 0232
Extended memory error. Error expanding memory with offset nnnn. Memory. System motherboard 0250.
Wrong system battery-system battery is damaged. Replace the spare battery and run the IBM BIOS setup tool to reset the date and time. 025 1
System CMOS check error-the default setting is to replace the spare battery and run the IBM BIOS setup tool to reset the date and time. 0252
Password verification error-password cleared. Enter the IBM BIOS setup tool to clear the password (reset) 0260.
System time error. Replace the spare battery and run the IBM BIOS setup tool to reset the date and time. System motherboard 0270
Replace the spare battery with a real-time clock and run the IBM BIOS setup tool to reset the date and time. System motherboard 027 1
Wrong date and time. The computer has not set a date or time. Run the IBM BIOS setup tool to reset the date and time 0280.
Incomplete boot error-The default setting uses the IBM BIOS setup tool to restore the default memory. System motherboard 02B2
Drive a is not the correct disk drive.
External floppy disk drive
I/O card 02F4
EISA CMOS can't write to IBM BIOS setup tool to restore the default settings, and replace the backup battery system motherboard 02F5.
Memory test failed. Memory. System motherboard 02F6
Software NMI fault memory. System motherboard 02F7
Fault safety timer NMI fault memory. System motherboard 180 1.
The connected docking station does not support turning off the computer and then moving it 1802.
Unauthorized network card insertion-install and then remove the miniPCI network card. Remove the miniPCI network card. System motherboard symptom or error FRU or operation (pay attention to order) device address conflict: device address conflict recovery default setting in BIOS setup tool Backup battery system motherboard device allocation error: device positioning error recovery default setting in BIOS setup tool Backup battery system motherboard fault bit: nnnn bit fault memory slot DIMM system motherboard. Invalid system configuration data: illegal system configuration data memory slot DIMM system motherboard I/O device IRQ conflict: device I/ O IRQ conflict Restore the default settings in BIOS setup tool. Backup battery system motherboard operating system not found: no operating system. Check whether the operating system is error-free and installed correctly. Enter the IBM BIOS setup tool to check whether the hard disk or floppy disk is correctly recognized. Reset the hard disk and reinstall the operating system floppy disk drive hard disk drive system motherboard motherboard. National error: Hibernation error recovery system is set to the state before hibernation. If the memory capacity changes, re-create the hibernation file (delete the hibernation file under C: and re-enter). Fan Error: Fan Error: Thermal Sensing Error: Thermal Sensing Error System Motherboard.