Start playing the first song on your CD. Gradually increase the volume until you feel that the subwoofer's speaker unit is moving back and forth. Then start to adjust the volume down. Low.

When you feel that the subwoofer still has a "safe volume" that can move back and forth, let it play at this volume for 2 hours, then increase the volume slightly again, let it play at this volume for 4 hours, and finally play continuously as needed. This disc is played for a whole day at your usual listening standards. Some high-end Hi End audio equipment may take more time to RUN IN, sometimes a week or even a month (some take more than half a year) to burn in.

If you want to RUN IN your amplifier, we recommend the following operation method. Place the two speakers face to face with a distance of 30cm. One of the speakers should be connected to the speaker cable in "reverse phase". If you do this, The sound produced by two speakers facing each other will be weakened due to the "reverse phase" that cancels out the sounds of the two speakers.

Theoretically, from the CD turntable, cables, amplifiers, speaker cables to the two speakers, if the two speakers are placed face to face like this, and one speaker is connected in anti-phase, as long as the left and right channels If the value is exactly the same, then it should be completely offset and there should be no sound.

This has two benefits. First, it ensures that it does not annoy your neighbors, and it is also beneficial to a quiet night's sleep. If you want to RUN IN the sound system at night, we would recommend that you do this. .

Each time you play this disc, please make sure the volume knob is at the lowest point, and then gradually increase the volume until you feel the bass unit begins to vibrate. You no longer need to increase the volume and start to enter the burn-in state. After playing it two to three times, increase the volume a little and run continuously for about four hours, and then turn the volume down a little to enter the continuous burn-in process.

It is recommended that each continuous burn-in should not exceed eight hours. If it is a vacuum tube machine or a pure class A amplifier, it should not exceed six hours. The interval between each burn-in should be Keep the shutdown time at least half an hour to ensure that the equipment has sufficient rest and cooling time.

Please ensure there is enough heat dissipation space around the equipment when burning it.

When using speakers that are brand new or have not been used for a long time, please follow the initial operation of the above basic burn-in procedure (see the volume operation when the bass unit starts to vibrate, and play it four to five times in a row before restarting) Enter the second step of the volume increase procedure), please "do not rush" to increase the volume to too high, which may cause damage to the speaker.

After a period of time (about one to two months), please use the ninth track on this disc: "Demagnetisin*** Track degaussing sound effect" to eliminate speakers, CD players, amplifiers, signal cables, and power cables. Wait for the magnetization problem on the connector.

In an environment where the temperature and humidity of the place where the speaker is placed varies greatly, and the speaker has not been used for a long time without sufficient operation, the speaker unit will often harden slightly; if it has been completed If the speaker with the above burn-in procedure has not been used for a period of time, it is recommended to use the initial basic procedure of this disc to run it once or twice before playing other music software.

After this disc is degaussed and burned in, it will give excellent improvements to the sound effects, transparency, details, dynamics, etc. of your sound system. You will be able to hear every note and every nuance. .

Note:

Please be careful when using this disc, and be sure to control the volume carefully, because all recordings are performed at -1dB. If you use it improperly, you may be It may cause damage to the valuable equipment in your home. STS assumes no responsibility for any damage to any equipment. But when used correctly, it can greatly improve the sound field, transparency, detail and dynamics of your equipment, especially the three-dimensional imaging of the sound field and the sound tone.