Beats Getting Started Instructions. Powering on

The power button is located on the cable below the right earphone. Press and hold the button for 1 second to power the headphones on or off. Setup

If the light on your headphones is on but not blinking, your headphones are set up with a device. In this case, follow the steps to connect to other devices.

If you have an iPhone with iOS 10, follow these steps. When you set up your headphones this way, if you have other supported devices that are signed in to iCloud and they're using iOS 10, macOS Sierra, or watchOS 3, they will also appear on those devices

Set up the headset automatically. Connect to other devices

Your headphones automatically reconnect to the device they were last used with. To connect to other devices, follow the steps below.

iPhone, iPad, or iPod touch with iOS 10:

1. Swipe up from the bottom edge of the screen to open Control Center.

2. In Control Center, swipe sideways to display the Now Playing card.

3. Tap the device name at the bottom of the card, then choose your headphones from the list of playback devices. If you don't see your headphones, follow the steps below for all other devices.

All other devices: Charging

Plug your headphones into a power source using the included Lightning cable. The headphones can play for up to 8 hours on a full charge and up to 2 hours on a 5-minute charge. Control Force Restart

1. Press and hold these two buttons for 10 seconds: Power button Volume + Down (–) button On. When the LED flashes, release the button.

2. Your headset is now force restarted and ready to set up again with your device.