First, adjust it with the water separator above the faucet. If it is a pull-type water separator, pull or push. If it's about to open, just adjust it. The one above the faucet and shower pipe joint is called the water separator.
Second, if the general dual-purpose switch has only one handle, there are two modes of movement: rotating and pulling. Try to pull up the rotation control thing and press the rotation control thing. You can also rotate to control one first, and then rotate to the other side to control the other. Switches usually have signs, such as signs for showers and faucets. Just adjust them to the corresponding positions.
3. At present, high-grade shower heads are generally designed with the above-mentioned water outlet mode, which can be simply adjusted according to their own needs. The adjustment method is simple. Press the small handle on the shower head or directly rotate the shower head to change the water outlet at will.
Four, the shower on the market at present is generally equipped with five ways of water:
1, the most basic shower water flow for bathing.
2, rain type, continuous drop by drop of water.
3, massage, strong spray, constantly pour, relax the body.
4, stroking, continuous small water flow.
5. A single stream of water is concentrated into a water column.
1, the ambient temperature should not exceed 70 degrees Celsius. High temperature and ultraviolet rays will greatly accelerate the aging of shower heads and shorten the service life of shower heads, so the installation of shower heads should be as far away from electrical heat sources such as Yuba as possible. Shower should not be installed directly under Yuba, and the distance should be greater than 60CM.
2. In areas with hard water quality, please try to choose a shower nozzle with rubber particles at the outlet or a direct cleaning device. Even if the outlet of the shower nozzle is blocked by scale, it is easier to clean. Remember not to forcibly disassemble the shower head, because the internal structure of the shower head is complex, and unprofessional forced disassembly will lead to the shower head not being restored to its original state.
3. Don't use too much force when turning on and off the shower faucet and adjusting the shower outlet mode, just turn it gently. Even traditional faucets don't need much effort. Pay special attention not to support or use faucet handles and shower racks as handrails.
4. The metal hose of the shower should be stretched naturally, and don't put it on the faucet when not in use. At the same time, be careful not to form a dead angle at the joint between the hose and the faucet, so as not to break or damage the hose.
5. Dismantle the shower head every six months or less, put it in a small basin, soak the surface and interior of the shower head with water and edible white vinegar for 4-6 hours, and then gently wipe the water outlet on the surface of the shower head with a cotton rag: after reassembling the joint, the water will flow for a period of time, thus eliminating or reducing the influence of scale on the shower head and achieving a certain sterilization effect.
6, often with a soft cloth dipped in a little flour to wipe the shower electroplating surface, and then rinse with water, so that the shower surface is as bright as new.